Projection Operations

Displaying the Pointer

Use the procedures in this section to display the pointer and to select its shape (arrow, bar). You can use the pointer to point to a specific location of the projected image during a presentation.

zThe pointer cannot be displayed while the projector is connected to a computer over a USB connection (page 75).

zThe pointer can be displayed regardless of the input source.

zYou can also select the pointer shape using “Option Settings2 J Pointer” (page 61).

zTrapezoid correction can cause certain pointer shapes to display improperly. If this happens, set the vertical and horizontal trapezoid correction values both to zero. See “Manual Keystone Correction” (page 10) for more information.

To display the pointer

Press the [POINTER/SELECT] key to display the pointer in the projected image. The following operations can be performed while the pointer is displayed.

zPressing the [STYLE] key (the [ENTER] key functions as the [STYLE] key while the pointer is displayed) changes the style of the pointer.

When the pointer is an arrow:

Each press of the [STYLE] key cycles through pointer shapes as shown below.

When the pointer is a bar:

Pressing the [STYLE] key causes the pointer to flash.

zThe cursor keys can be used to move pointer around the image. Holding down a cursor key moves the pointer at high speed.

18