Casio pmn Using the Setup Menu, Setup Menu Overview

Using the Setup Menu

Setup Menu Overview

Pressing the [MENU] key while an image is being projected displays the setup menu on the projected image. The setup menu can be used to configure a variety of different projector settings. The following table shows the menu items that are available in the Setup Menu.

Main menu		Sub-menu	Sub-menu Item Type*1		Input source*2					See
				R		C	S	V	–	page
		Brightness	Value Setting							31
		Contrast	Value Setting							31
		Sharpness	Value Setting							31
		Saturation	Value Setting							31
		Tint	Value Setting				*4	*4		31
Image		Color Mode	Setting Screen							32
		Color Balance	Setting Screen							32
Adjustment
		Vertical Position	Value Setting							34
		Horizontal Position	Value Setting							34
		Frequency	Value Setting							34
		Phase	Value Setting							34
		Noise Filter	Selection							35
	Restore Menu Defaults		Execution							35
Volume		Volume	Value Setting						*3	35
Adjustment	Restore Menu Defaults		Execution							35
		Vertical Keystone	Value Setting							36
		Correction
		Horizontal Keystone	Value Setting							36
		Correction
		Aspect Ratio	Selection			*5				37
Screen	Resize Image To Fit		Selection							38
Settings		Projection Mode	Selection							39
		Ceiling Mount	Selection							39
		Startup Screen	Selection							40
		No Signal Screen	Selection							40
		Mute Screen	Selection							41
	Restore Menu Defaults		Execution							41
*1 This is the sub-menu item type. Refer to the pages noted below for more information.
Value Setting: Specifies a numeric value () page 26).
Selection:		Allows selection from multiple options () page 26).
Setting Screen: Numeric value specification or option selection on a separate setting
		screen () page 27).
Execution:		Initializes a setting () page 28).
Information:		Displays information only () page 28).
*2 These columns indicate whether each item appears ( ) or not (						) for each input
source (R = RGB, C = Component, S = S-VIDEO, V = Video, – = No input signal).
*3 This setting is for the currently selected input source.
*4 This setting can be configured only for an NTSC or NTSC4.43 signal.
*5 This setting can be selected only when the aspect ratio of the input signal is 4:3.

21