em (ENTER)

Sounding Arpeggios Automatically (Tutorial)

To select a different arpeggio for each zone

1. Hold down the bn (ARPEGGIO) button until the arpeggio type selection screen appears on the display.

This will cause the button’s lamp to light.

2. Use the dk (ZONE, –/+)buttons to display the number of the zone you want to select.

Zone number

3. After making sure that X is next to the arpeggio number, display the number of the arpeggio you want to select for the zone.

•Repeat steps 2 and 3 as many times as necessary to select arpeggios for each of the zone.

To turn the arpeggio for a specific zone on or off

1. Hold down the bn (ARPEGGIO) button until the arpeggio type selection screen appears on the display.

This will cause the button’s lamp to light.

2. Use the ds (u), dt (w), ek (q), and el (i) buttons to select “ZONE”.

3. Use the eo minus (–)and plus (+) buttons to turn the arpeggio of the zone on or off.

NOTE

•Note that no arpeggio also will play if the zone has been muted. To unmute a zone, press the dr (EXIT) button to exit the arpeggio type selection screen, and then press the two dk (ZONE, –/+)buttons at the same time.

Editing an Arpeggio

There are two arpeggio types: step type and variation type.

•With a step type arpeggio, you can edit its steps and its parameters. A step type arpeggio can contain up to 16 steps. You can change the following settings for each step.

TYPE : Specifies which note of the arpeggio should be played in each step, in relation to the lowest note (L1) or the highest note (U1) of the arpeggio. There is also a TYPE (P2-P5) that can be used to sound up to five notes at the same time.

NOTE : When you want to shift the note from the keyboard key that is pressed, use this setting specify the shift value in semitone steps.

VELO : Specifies the volume level.

CTRL : This is MIDI control data.

•With a variation type arpeggio, you can edit only its parameters.

1. Select the arpeggio type you want to edit.

2. Press the ep (EDIT) button.

3. Use the dt (w) and ek (q) buttons to select “Step Edit” and then press the

button.

•The “Step Edit” option will not be displayed if you selected a variation type arpeggio in step 1, above.

E-25