Sounding Arpeggios Automatically (Tutorial) 
6.
7.
Use the dt (w) and ek (q) buttons to move the selection cursor (0) to “Parameter” and then press the em (ENTER) button.
Change parameters as desired.
•The table below shows the contents of the arpeggio parameter editing menu.
Menu Level
1 | 2 | Description |
|
| Setting |
|
|
|
| ||
|
|
|
|
| |
Parameter >Ent |
|
|
|
| |
|
|
|
|
|
|
| Max Step | Maximum step. This parameter can be changed for | 1 - 16 |
|
|
|
| step type only. |
|
|
|
| Step Size | Step size. Specifies the note length between steps. | 2, 6, | , 7, | , 8 |
|
|
|
|
|
|
|
| Note length. Note on note length specified as a |
|
|
|
| Note Length | percentage of the step size. 100% specifies the same | 1 - 100% |
|
|
| size as the original, while 50% specifies a note |
|
| ||
|
| length that is half the original. |
|
|
|
|
|
|
|
|
|
|
| Groove. Specifies the on note timing of the |
|
|
|
| Groove | step. 50% specifies even, while a larger value | 10 - 90% |
|
|
|
| increases the first half note length. |
|
|
|
|
|
|
| ||
|
|
| Normal: Playback performed with | ||
|
| Groove type. Specifies the note length type when | step length based on actual | ||
| Groove Type | percentage. |
| ||
|
| anything other than 50% is specified for Groove. | Short: When step length is changed, | ||
|
|
| |||
|
|
| adjusts the step to the shorter length. | ||
|
|
|
|
|
|
|
| Velocity. Specifies the velocity value of an input |
|
|
|
| Velocity | arpeggio. Specifying “KeyOn” inputs a velocity | KeyOn, 1 to 127 | ||
|
| value in accordance with applied key pressure. |
|
|
|
|
|
|
|
|
|
| Hold Pedal | Hold pedal. Enables/disables hold using a pedal. | Off, On |
|
|
| This parameter can be changed for step type only. |
|
| ||
|
|
|
|
| |
|
|
|
|
|
|
|
| Control track. Enables (On) or disables (Off) use of |
|
|
|
| Control | control data. Selecting “Only” causes only the | Off, On, Only |
| |
| Track | control track to be valid. This parameter can be |
| ||
|
|
|
| ||
|
| changed for step type only. |
|
|
|
|
|
|
|
|
|
| Control | Control type. Specifies the control data type. This | Bend, C. (Control Change) 00 - 97 | ||
| Type | parameter can be changed for step type only. | |||
|
|
|
| ||
|
|
|
|
|
|
|
| Smooth. Selecting “On” causes control data to be |
|
|
|
| Smooth | supplemented. This parameter can be changed for | Off, On |
|
|
|
| step type only. |
|
|
|
|
|
|
|
|
|
•For information about parameters that need to be edited to playback an arpeggio with a stage setup, see “Using the Stage Setups (Tutorial)” (page