*The PREFLASHING MODES mentioned on page 28 are described below:
MODE 1 - COURTESY LIGHT PREFLASHES AT 1 HZ, THEN ACTS AS COURTESY LIGHT.
MODE 2 - COURTESY LIGHT FLASHES AT 1 HZ FOR PREFLASH TIME AND THEN FLASHES IN SYNCHRONISM WITH THE STATUS LED WHILE THE MOTOR RUNS.
MODE 3 - COURTESY LIGHT ON CONTINUOUSLY FOR PREFLASH TIME AND MOTOR RUN TIME ONLY.
TIMER and COUNTER SETTING
Various timers and counters can be programmed. The procedure is described below in conjunction with Table 3, page 30.
STEP 1 - Ensure controller is in Programme Mode (see page 21).
STEP 2 - Press and hold the TEST pushbutton while monitoring LED L1.
STEP 3 - L1 will flash once then go off, twice in short succession then go off, 3 times then go off, etc.
STEP 4 - Release TEST pushbutton when the desired MAIN MENU item in Table 3 is required.
STEP 5 - To select required time (or count) hold TEST pushbutton while monitoring STATUS LED. After a short time STATUS will flash continuously and regularly. Each flash represents a unit of measure (i.e. time, distance or count).
Release TEST pushbutton when the required subdivision is selected. L2 will come ON to indicate that the controller is back in PROGRAMME MODE and another TIMER or FUNCTION (refer to procedure on page 27) can be programmed.
STEP 6 - Remove SET link when all programming is complete.
29
