A5 MOTOR MANUAL SET-UP

STEP 1 ALIGN ORIGIN SWITCH

- Start with gate fully closed.

- Push gate open (origin marker must have moved well past origin switch).

- Push gate closed again.

STEP 2 - ENSURE PCB IS IN PROGRAMME

MODE (refer procedure page 21)

STEP 3 - SET LIMITS

- Press TEST pushbutton until LED L1 flashes once and release.

-L1 will continue to flash once and L2 will go out.

-Press TEST pushbutton until STATUS LED

comes ON and release (check that L1, L2 & STATUS are OFF)

STEP 4

- Push gate to fully “OPEN” position and do not allow gate to reverse.

- Press TEST pushbutton until STATUS LED comes ON and release.

STEP 5

- Push gate to fully “CLOSED” position hard up against endstop and do not allow gate to reverse.

- Press TEST pushbutton until STATUS LED comes ON and release.

 

 

 

 

STEP 6

 

 

 

“PED”

- Push gate to “PEDESTRIAN” open position.

 

 

 

 

 

 

- Press TEST pushbutton until STATUS LED

 

 

 

 

comes ON and release. If STATUS LED

 

 

 

 

does not come ON, increase pedestrian

 

 

 

 

 

 

 

 

opening until it does.

26

Page 28
Image 28
Centurion CP72SR5 installation manual A5 Motor Manual SET-UP, Align Origin Switch