Christie Digital Systems CSP70 user manual Remote Control of the Projector

Section 3: Operation

3.11Remote Control of the Projector

3.SET STARTING POINTS FOR ADJUSTMENT:

Set all blend widths to 0.

Go to “More” and set everything in the Edge Blending (2) menu to 50.

Figure 3.37. Set Starting Points for Each Projector

4.SET BLEND WIDTH: On one projector, increase the Blend Width for an overlapping edge (for example, if the projector’s image is on left, its right edge overlaps the adjacent image—adjust Right Blend Width). Use the same setting on the second projector for this shared edge.

5.Re-adjust width (both projectors) until the overly bright band at the midpoint of the overlapping blends disappears or just changes to very light gray. For the shared edge, use the same Blend Width setting on each projector. If the best effect appears to be between two settings, choose the wider setting for both projectors.

6.CHECK BLEND: If the blended region appears too dark or light in relation to the rest of the image:

Increase Blend Midpoint in both projectors to “lighten” the overall blend, decrease to “darken” the overall blend.

Adjust Blend Shape in both projectors to fine-tune change the amount of mid- gray intensity (as opposed to black/white) in the blend.

7.Repeat with remaining projectors / overlaps.

8.Check completed display wall with the desired external signal.

9.Adjust mechanical alignment if necessary to maintain perfect pixel-on-pixel alignment over time.

In applications where you are projecting only white or light images, the Blend Width may be slightly higher—set according to how much overlap you have between images.

As an alternative to using a keypad, most projector functions can be controlled remotely, typically at a controller such as a PC, via 1) simple bi-directional ASCII messaging on an Ethernet or serial communication link or 2) a web interface or “ChristieNET” on an Ethernet network.

VIA ASCII MESSAGING — Connect a serial link between your controller and the RS232 or RS422 port (recommended), or open an Ethernet socket (i.e., Telnet) between your controller and the valid projector address. Valid ASCII codes and messages are documented in the Christie Serial Communications document available at the Christie website.

RPMSP & CSP70-D100U User’s Manual 3-59