Christie Digital Systems CSP70 user manual Inside the Lamp Compartment

Power*

Section 4: Maintenance

Figure 4.6. Inside the Lamp Compartment

Step 5 ' Close lamp door – Once the lamp is inserted, carefully close the spring-loaded lamp door and lock it by tightening the two lamp door screws.

Watch your fingers! The lamp door is spring- loaded and will snap close. Keep fingers clear from the lamp compartment opening when closing the lamp door.

Step 6 ' Turn the Projector on (if applicable) or Switch back to the original Lamp

Operation Mode – Press to turn the projector on. If you performed a hot- swap, use the Lamp menu to return to the original lamp operation mode you were in.

Step 7 ' Reset Lamp Hours – Access the Lamp menu (item 5. in Main Menu) and select the submenu for the lamp that you are replacing – More, Lamp 1 or More, Lamp 2. From the submenu, select the Change Lamp option. Enter the new serial number in the Lamp S/N text box. When the new number is recorded, the lamp timer will automatically reset to “0” hours and begin to log time.

NOTES: 1) Once entered, the new lamp serial number is also automatically added to the Lamp History submenu (read-only). 2) Lamp life data is required for warranty claims.

IMPORTANT

If you fail to enter a serial number the lamp timer will not automatically reset to “0” and inaccurate lamp hours will be shown in the Status menu. The lamp life limit may then expire prematurely.

RPMSP & CSP70-D100U User’s Manual 4-9