Cisco Systems 2800 manual Installing the Router, Statement

Warning

Warning

Warning

Warning

Warning

Note

Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement 1030

To prevent personal injury or damage to the chassis, never attempt to lift or tilt the chassis using the handles on modules (such as power supplies, fans, or cards); these types of handles are not designed to support the weight of the unit. Statement 1032

This equipment must be installed and maintained by service personnel as defined by AS/NZS 3260. Incorrectly connecting this equipment to a general-purpose outlet could be hazardous. The telecommunications lines must be disconnected 1) before unplugging the main power connector or 2) while the housing is open, or both.

Statement 1043

Ultimate disposal of this product should be handled according to all national laws and regulations. Statement 1040

To prevent the system from overheating, do not operate it in an area that exceeds the maximum recommended ambient temperature of 40 deg. Statement 1047

This product requires surge protection to be provided as part of the building installation. To comply with the Telcordia GR-1089 NEBS standard for electromagnetic compatibility and safety, an external Surge Protective Device (SPD) is required at the AC power service equipment (see definition in the NEC).

Installing the Router

Note Cisco 2800 series routers are normally ordered with modules and interface cards. Before you remove or install any modules or interface cards, see the documents that accompany those items or to the online Cisco 2800 series hardware installation documentation at the following URL:

http://www.cisco.com/univercd/cc/td/doc/product/access/acs_mod/2800/hw/index.htm

For module and interface card compatibility information, see the data sheet for each module and interface card.

Warning Before working on a system that has an on/off switch, turn OFF the power and unplug the power cord. Statement 1

You can set any Cisco 2800 series router on a desktop or install it in a rack. A Cisco 2811 router can also be mounted on a wall or other flat surface. See the applicable instructions in the following sections.

•Rack-Mounting the Router, page 13

•Wall-Mounting the Router—Cisco 2811 Routers Only, page 16

•Installing the Router on a Desktop, page 17

Caution To prevent damage to the chassis, never attempt to lift or tilt the chassis by the plastic panel on the front. Always hold the chassis by the metal body.

12