Electrical hazards. Statement | Cisco Systems 2800 specs

Step 6 Install the plastic covers over the terminals. (See Figure 19 or Figure 20.)

Warning	The safety cover is an integral part of the product. Do not operate the unit without the safety cover installed.
	Operating the unit without the cover in place will invalidate the safety approvals and pose a risk of fire and
	electrical hazards. Statement 117

Step 7 Organize and secure the wires using cable ties as shown in Figure 19 or Figure 20. Make sure that the wires do not project above or below the front panel of the router.

Step 8 Turn on power to the DC circuit. Be sure to remove tape used to secure the circuit-breaker switch in the OFF position.

Figure 19 DC Wire Routing and Attachment for Cisco 2811 Routers

24-60V	--- 8A

-

A

+ +

B

-

Cable tie

From DC power source

111814

Plastic covers

Figure 20 DC Wire Routing and Attachment for Cisco 2821 and Cisco 2851 Routers

1	CONSOLE
1
0
	AUX

24-60V	--- 12A

-

Cable tie

A	+

+	B	-

From DC power source

Plastic covers

111815

23

Image 23

Cisco Systems 2800 manual Electrical hazards. Statement, DC Wire Routing and Attachment for Cisco 2811 Routers

Contents

Including License and Warranty Replacement, Repair, or Refund Policy for Hardware Cisco 90-Day Limited Hardware Warranty TermsDuration of Hardware Warranty Overview To Receive a Return Materials Authorization RMA Number Serial Number Label Location for Cisco 2801 Router Product Serial Number Location Translated Versions Documents, Equipment, and ToolsUser Documentation Items Included with Cisco 2801 Routers Items Not Included Install ChassisSafety Information Page OBS! Spara Dessa Anvisningar Guarde Estas Instruções GEM Disse Anvisninger Page Statement Installing the Router Attaching Brackets to the Router for Rack-Mounting Rack-Mounting the Router Bracket Installation for Front Mounting Installing the Router in a Rack Attaching Brackets to the Router for Wall Mounting Wall-Mounting the Router-Cisco 2811 Routers Only Ground during normal use. Statement Installing the Router on a DesktopGrounding the Chassis Chassis Ground Connection on Cisco 2801 Chassis Connect Cables 120 VAC, 15 a 240 VAC, 10 A. Statement Power ConnectionsConnecting the Router to AC Power Protective device is rated not greater than Use copper conductors only. Statement Connecting the Router to DC PowerSize Wire Terminal Lug Protection 60 VDC, 20 A. Statement Be connected first and disconnected last. Statement TipInsulation and conductor. Statement Step Electrical hazards. Statement DC Wire Routing and Attachment for Cisco 2811 Routers Connecting to One Source Only-Source a or Source B Source a and Source B Wired with Opposite-Polarity Grounds WAN, LAN, and Voice Connections Connecting the Router to Backup Power T1/E1 WAN Port or Connection Port Type, Color Cable Port Color Connection Cable Power Up the RouterChecklist for Power-Up System Management Connections Power-Up Procedure LED Label LED Color or State Meaning Verify the Hardware ConfigurationInterface Numbering Verify the Front Panel LED Indications Port Location Interface Numbering Scheme Examples1 Slot Type Interface Numbering Range Perform Initial Configuration Initial Configuration Using the Setup Command Facility Summary of the available interfaces appears User prompt appears To access documentation using Cisco Connection Online CCO Where to Go NextVerify the Initial Configuration To access documentation on Cisco.com Ordering Documentation Obtaining DocumentationCisco.com Product Documentation DVD Cisco Product Security Overview Reporting Security Problems in Cisco ProductsDocumentation Feedback Cisco Technical Support & Documentation Website Submitting a Service RequestDefinitions of Service Request Severity Obtaining Technical Assistance Obtaining Additional Publications and Information Page Page Page Page USA