Cisco Systems 4500E manual Action, Explanation, the “Streaming Settings Window” procedure on, page

Chapter 2 Getting Started

Installing the IP Camera

Table 2-1	Installing the IP Camera (continued)
	Action	Explanation
Step 3	Optional. Use the audio Y cable to connect a speaker,	Each device connects to the audio Y cable through a
	microphone, or both devices to the audio port on the rear	standard 3.5 mm mini phone jack. A speaker connects to
	of the IP camera.	the red jack (speaker out) and a microphone connects to
		the black jack (mic in). The Y cable that is included in the
		optional audio/video cables accessory kit can be
		purchased from Cisco (Cisco part number
		CIVS-IPCA-1021=).
		A speaker plays audio that is captured by a microphone
		that is attached to the PC on which you view video from
		the camera.
		Place the external microphone in a location that allows it
		to capture the audio that you want.
		Note By default, the IP camera does not transmit or
			receive audio. To enable and configure audio, see
			the “Streaming Settings Window” procedure on
			page 3-3.
Step 4	Optional. Use the mini cable with BNC connector to	The analog video device displays video from the
	temporarily attach an NTSC or PAL compliant analog	IP camera. The display does not include the time stamp or
	video display device to the analog video out port on the	text that are configured for the camera.
	rear of the IP camera for installation purposes.	Connect the monitor BNC connector to the mini cable
		with BNC adapter, then plug the cable into the analog
		video out port. The mini cable with BNC adapter is
		included in the audio/video cables accessory kit, which
		you can purchase from Cisco (Cisco part number
		CIVS-IPCA-1021= ).
		Analog video is enabled by default to allow you to adjust
		the camera field of view during installation. However, it is
		not supported as a normal camera feed and is
		automatically disabled when any of the following camera
		settings are made:
		•	Audio is enabled
		• Resolution is set to 1080p
		• Framerate is set to 60 fps
		•	Mjpeg is enabled
		• H.264 and mjpeg are both enabled
		Note We recommend that you disable analog video after
			installation. To disable analog video, see the
			“Streaming Settings Window” procedure on
			page 3-3.

Cisco Video Surveillance 4300E and 4500E High-Definition IP Camera User Guide

OL-25230-02 2-3