Cisco Systems 4300E, 4500E manual “Streaming Settings Window” section on page, Video image controls

Chapter 4 Viewing Live Video

Table 4-1 Camera Video/Control Window Controls (continued)

Control	Description
Video Resolution	Choose the resolution for video transmission. The resolutions in this
drop-down list	drop-down list depend on the video standard that you selected.
	The default value for H.264 is 1920 x 1080. The default value for MJPEG is
	704 x 480.
	You cannot configure a secondary stream if you configure this resolution for
	1920 x 1080.
	Note You can also change the resolution for video transmission by changing
	the value in the Video Resolution Type field, as described in the
	“Streaming Settings Window” section on page 3-3.
Right Arrow toggle	Click the Right Arrow to display the video image controls. The button changes
button	to the Left Arrow button.
	Click the Left Arrow button to hide the video image controls. The button
	changes to the Right Arrow button.
Left Arrow toggle
button

Video image controls

Note These controls appear when you click the Right Arrow in the Video Control area.

White Balance slider	To control the white balance of the video image, drag the slider, or enter a
	value from 1 through 100 and press the Enter key. A higher value increases
	white balance and a lower value decreases white balance.
	If the White Balance Mode option is not set to Manual as described in the
	“Camera Settings Window” section on page 3-6, changing the white balance
	value sets that option to Manual automatically.
	The default value is 50.
Brightness slider	To control the brightness of the video image, drag the slider, or enter a value
	from 1 through 100 and press the Enter key. A higher value increases the
	brightness and a lower value decreases the brightness. For example, if the IP
	camera is facing a bright light and the video appears too dark, you can increase
	the brightness.
	The default value is 50.
Contrast slider	To control contrast of the video image, drag the slider, or enter a value from 1
	through 100 and press the Enter key. A higher value increases the contrast and
	a lower value decreases the contrast.
	The default value is 50.
Sharpness slider	To control the sharpness of the video from the IP camera, drag the slider, or
	enter a value from 1 through 100 and press the Enter key. A higher value
	increases the sharpness and a lower value decreases the sharpness.
	The default value is 50.

Cisco Video Surveillance 4300E and 4500E High-Definition IP Camera User Guide

4-2 OL-25230-02