Chapter 3 Installing the Cisco ASR 901 Mobile Wireless Router
Powering On the Router
For more information about 10Mhz and 1PPS port pinouts, see “GPS Port Pinouts” section on page
Connecting Cables to the ToD Interface
Complete these steps to connect cables to the ToD interface for GPS timing.
Step 1 Confirm that the router is powered off.
Step 2 Connect one end of a
Step 3 Connect the other end of the cable to the ToD port on the Cisco ASR 901 router.
For instructions on how to configure clocking, see the Cisco ASR 901 Router Software Configuration Guide.
Note For more information about BITS port pinouts, see “Time of Day Pinouts” section on page
Connecting to Alarm Port
Use a straight cable to connect to the alarm port. For details on the pinouts, see “Alarm Port Pinouts” section on page
Connecting to the Management Ethernet Port
Use a straight or a cross over ethernet cable to connect to the management ethernet port. For details on the pinouts, see “Management Ethernet Port Pinouts” section on page
Dressing Router Cables
Ensure all Cisco router cables are properly dressed so as not to interfere with each other or other pieces of equipment. Use local practices to ensure that the cables attached to your router are properly dressed.
Note If your Cisco ASR 901 router is
To continue the installation, proceed to the next section, “Powering On the Router.”
Powering On the Router
Warning Do not touch the power supply when the power cord is connected. For systems with a power switch, line voltages are present within the power supply even when the power switch is off and the power cord is connected. For systems without a power switch, line voltages are present within the power supply when the power cord is connected. Statement 4
|
| Cisco ASR 901 Series Aggregation Services Router Hardware Installation Guide |
|
| |
|
|
| |||
|
|
|
| ||
|
|
|
| ||
