Installing a Packet Voice Data Module
Installing a Packet Voice Data Module
You can install a packet voice data module (PVDM) to support enhanced versions of digital signal processors (DSPs).
Follow these steps to install a PVDM on the router motherboard:
Warning During this procedure, wear grounding wrist straps to avoid ESD damage to the router. Do not directly touch the backplane with your hand or any metal tool, or you could shock yourself.
Step 1 Locate the PVDM slot on the motherboard, shown in Figure 2.
Step 2 Remove any existing PVDM by pulling the PVDM snaps (shown in Figure 7) away from the PVDM.
Step 3 Hold the replacement PVDM with the double notched edge on your left.
Step 4 Insert the PVDM into the PVDM slot, making sure that the notches on the edge of the PVDM are inserted over the bars inside the PVDM slot, as in Figure 7.
Step 5 Push the module towards the slot and press firmly until you hear a clicking sound and the module is firmly seated in the slot, as shown in Figure 7.
Figure 7 Installing a PVDM
PVDM module
1
PVDM snaps
2
PVDM slot 22310
Cisco 1750 Router Hardware Installation Guide
x |
| |
|