Cisco Systems OL-7861-01 manual Mylar Tab SFP Module, Installing a Bale Clasp SFP Module

Removing and Installing SFP Modules

Step 6 Protect your line card by inserting clean SFP module cage covers into the optical module cage when there is no SFP module installed.

Installing a Bale Clasp SFP Module

To install this type of SFP module, follow these steps:

Step 1 Attach an ESD-preventive wrist or ankle strap and follow its instructions for use.

Step 2 Close the bale clasp before inserting the SFP module.

Step 3 Line up the SFP module with the port and slide it into the port. (See Figure 19.)

Figure 19 Installing a Bale Clasp SFP Module into a Port

	2
ACTIVE	CARRIER	RX PACKET

PASS	THRU
	WRAP

	3
ACTIVE	CARRIER	RX PACKET

PASS	THRU
	WRAP
	4OC48/SRP-
	SFP

84507

Note Verify that the SFP modules are completely seated and secured in their assigned receptacles on the line card by firmly pushing on each SFP module. If the SFP module was not completely seated and secured in the receptacle, you will hear a click as the triangular pin on the bottom of the SFP module snaps into the hole in the receptacle.

Mylar Tab SFP Module

The mylar tab SFP module has a tab that you pull to remove the module from a port. (See Figure 20.)

Cisco XR 12000 Series Router Ethernet Line Card Installation

28 OL-7861-01