Cisco Systems OL-7861-01 Line Card Cable-Management Bracket, Installing a Slide Tab SFP Module

Line Card Cable-Management Bracket

Figure 29 Installing a Slide Tab SFP Module

	2
ACTIVE	CARRIER	RX PACKET

PASS	THRU
	WRAP

	3
ACTIVE	CARRIER	RX PACKET

PASS	THRU
	WRAP
	4OC48/SRP-
	SFP

84649

Note Verify that the SFP modules are completely seated and secured in their assigned receptacles on the line card by firmly pushing on each SFP module. If the SFP module was not completely seated and secured in the receptacle, you will hear a click as the triangular pin on the bottom of the SFP module snaps into the hole in the receptacle.

Line Card Cable-Management Bracket

Note The illustrations in this section show various line cards, but the line card cable-management bracket installation procedure is the same regardless of the specific line card.

Cisco XR 12000 Series Routers include a cable-management system that organizes the interface cables entering and exiting the router, keeping them out of the way and free of sharp bends.

Caution Excessive bending of interface cables can damage the cables.

The cable-management system consists of two separate components:

1.A cable-management tray that is mounted on the chassis. Refer to the appropriate Cisco XR 12000 Series Router installation and configuration guide for more information on the cable-management tray.

Cisco XR 12000 Series Router Ethernet Line Card Installation

36 OL-7861-01