Cisco Systems OL-7861-01 manual Slide Tab SFP Module, Installing an Actuator Button SFP Module

Removing and Installing SFP Modules

Step 6 Protect your line card by inserting clean SFP module cage covers into the optical module cage when there is no SFP module installed.

Installing an Actuator Button SFP Module

To install this type of SFP module, follow these steps:

Step 1 Attach an ESD-preventive wrist or ankle strap and follow its instructions for use.

Step 2 Line up the SFP module with the port and slide it in until the actuator button clicks into place. (See Figure 25.) Be sure not to press the actuator button as you insert the SFP module because you might inadvertently disengage the SFP module from the port.

Figure 25 Installing an Actuator Button SFP Module

	2
ACTIVE	CARRIER	RX PACKET

PASS	THRU
	WRAP

	3
ACTIVE	CARRIER	RX PACKET

PASS	THRU
	WRAP
	4OC48/SRP-
	SFP

84505

Note Verify that the SFP modules are completely seated and secured in their assigned receptacles on the line card by firmly pushing on each SFP module. If the SFP module was not completely seated and secured in the receptacle, you will hear a click as the triangular pin on the bottom of the SFP module snaps into the hole in the receptacle.

Slide Tab SFP Module

The slide tab SFP module has a tab underneath the front of the SFP module that you use to disengage the module from a port. (See Figure 26.)

Cisco XR 12000 Series Router Ethernet Line Card Installation

OL-7861-01 33