Cisco Systems SGH-Blast Series Make the second call in the normal way, Putting a Call on Hold

t729.book Page 24 Thursday, July 5, 2007 3:47 PM

Selecting Functions and Options

Putting a Call on Hold

You can place the current call on hold whenever you want. If your netowrk supports this service, you can also make another call while a call is in progress.

To place a call on hold:

1.Press the Options soft key, highlight the Hold option, then press the Select

soft key or the key.

2.Press the Resume soft key to reactivate the call.

To make a new call while a call is in progress:

1.Enter the new phone number that you wish to dial or look it up in the Contact list.

2.Press the key to dial the second call. The first call is then automatically put on hold. - Or -

1.Press the Options soft key, select Hold, and press the key. This places the currently active call on hold and allows to make a new call.

2.Make the second call in the normal way.

When there is an active call and a call on hold, you may switch between the two calls by placing the current held call to active and then placing the other call on hold.

To switch between the two calls:

1.Press the Options soft key, select Swap, and press the key. The current active call is placed on hold and the call on hold is then reactivated

so that you can continue conversing with that person.

2.Press the key when you are finished or want to end the call.

Using the Speakerphone

While on a call, you can use your Speakerphone by following these steps:

1.Press the Spkr on soft key.

2.To turn the Speakerphone off, press the Spkr off soft key.

Important!: For safety information related to speakerphone use, see "Responsible Listening" on page 141.

Call Functions 24