Cisco Systems SLM248G4PS, SLM224G4PS manual Port Management Port Settings Port Configuration

Chapter 5 Configuration Using the Web-based Utility

Speed  The port’s configured rate in Mbps.

Duplex  The port’s current duplex mode, Half or Full.

MDI/MDIX  The port’s MDI/MDIX type.The MDI setting is used if the port is connected to an end station. The MDIX setting is used if the port is connected to a hub or another switch.

Flow Control  This is the flow control status of the port. It is active when the port uses Full Duplex Mode.

Type  Displays the port type.

LAG  This indicates if the port belongs to a LAG.

Port Configuration

The Port Configuration screen lets you configure a port’s settings. To use this screen, click Detail in the Detail column on the Port Settings screen.

Port Management > Port Settings> Port Configuration

The Port Configuration screen contains the following fields (“Read-only” indicates that a field cannot be edited).

Port  The port number. To edit the information for another port, select the port from the drop-down menu. (Port numbers consist of either “e” for Ethernet, or “g” for Gigabit, followed by the appropriate number.)

Description  The user-defined port description of up to 64 characters. This field is blank by default.

Port Type  (Read-only) The port’s connection type and speed. The types are:

•copper  The port has a copper connection.

•ComboC  The Gigabit port has a copper connection.

•ComboF  The Gigabit port has a fiber optic connection.

The port speed is prefixed onto the type, for example 10M-copperindicates a 10 Mbps copper connection.

Admin Status  The port’s administrative status. Select either Up or Down to enable or disable traffic forwarding through the port.

Current Port Status  (Read-only) The port’s connection status, either Up or Down.

Reactivate Suspended Port  If the port has been suspended, select this checkbox to reactivate the port.

Operational Status  (Read-only) Displays whether the port is operational or non-operational.

Admin Speed  Use this to manually set the port’s configured transmission rate in Mbps. You can select 10M, 100M, or 1000M (Gigabit ports only). Before you change this setting, make sure that Auto Negotiation is disabled.

Current Port Speed  (Read-only) The port’s current rate in Mbps.

Admin Duplex  The port’s duplex mode, either Full or Half.

Current Duplex Mode  (Read-only) The port’s current duplex mode.

Auto Negotiation  Select Enable (default) or Disable to enable or disable Auto-Negotiation on the port. Auto- Negotiation allows a port to advertise its transmission rate, duplex mode, and flow control settings to other ports. If you are using an SFP module on a port, Auto Negotiation for that port should be set to Disable.

Current Auto Negotiation  (Read-only) The port’s current Auto-Negotiation status.

Admin Advertisement  Select the speed(s) and duplex mode(s) that the port will advertise. The available speeds are determined by the port type. The following capabilities are supported.

•Max Capability  The port advertises all speeds and duplex mode settings.

•10 Half  The port advertises 10 Mbps half-duplex operation.

•10 Full  The port advertises 10 Mbps full-duplex operation.

•100 Half  The port advertises 100 Mbps half-duplex operation.

•100 Full  The port advertises 100 Mbps full-duplex operation.

•1000 Full  (Gigabit ports only) The port advertises

1000 Mbps full-duplex operation.

Current Advertisement  (Read-only) The speed and duplex mode settings that the port is currently advertising.

24/48-Port 10/100 + 4-Port Gigabit Smart Switch with Resilient Clustering Technology and PoE 21