Voice Gateway with Router

Windows 2000 or XP Instructions

1. Click Start and Run. In the Open field, enter cmd. Press the Enter key or click the OK button.

2. At the command prompt, enter ipconfig /all. Then press the Enter key.

3. Write down the Physical Address as shown on your computer screen; it is the MAC address for your Ethernet adapter. This appears as a series of numbers and letters.

The MAC address/Physical Address is what you will use for MAC address cloning.

Figure B-3: MAC/Physical Address

The example shows the Ethernet adapter’s IP address as 192.168.1.100. Your computer may show something different.

For the Voice Gateway’s Web-based Utility

For MAC address cloning, enter the 12-digit MAC address in the field provided.

 

Figure B-4: MAC Address Cloning

66

Appendix B: Finding the MAC Address and IP Address for Your Ethernet Adapter

 

Windows 2000 or XP Instructions

Page 74
Image 74
Cisco Systems SPA3102 manual Windows 2000 or XP Instructions, For the Voice Gateway’s Web-based Utility