Installing Adapters in the
Step 3 Connect all external cables and the power cord to the appliance, and then plug the power cord into a properly grounded electrical outlet.
Installing Adapters in the WAE-512 and WAE-612 Appliances
This section describes how to install the inline network adapter in the
•Removing the Cover
•Installing an Inline Network Adapter
•Completing the Installation
Removing the Cover
Warning | Before working on a chassis or working near power supplies, unplug the power cord on AC units. | |
| Statement 246 |
|
|
| |
| To remove the cover, follow these steps: | |
|
| |
Step 1 | Review the information in the “Safety Guidelines” section on page 5. | |
Step 2 | Power down the device and all attached devices. Disconnect the power cord and all external cables. | |
Step 3 | Press the cover release button (labeled 1 in Figure 7). | |
| Figure 7 | Removing the Cover |
1
151926
Step 4 While holding the cover release button down with your thumb, lift the opposite front corner of chassis slightly with your other hand, and using your free thumb, slide the cover back approximately 0.5 inches (1.27 cm); then lift it up and off the device.
Installing the Cisco WAE Inline Network Adapter
| 13 |
| |
|
|
