3-9
3.5 Ribbon Setting
CAUTION Be careful of the edges of the plates so injury or
property damage is possible.
After opening the cover,set the ribbon as follows:
1 Push down the open lever 1 tomove the print head out of the way.
2 Insert the ribbon shaft 11 in the roll ribbon so that it is in its deepest position.
Then set it inthe ribbon holder as shown in the figure.
3 Insert the ribbon shaft 12 in the paper core 13 so that it is in its deepest
position. Then set it in the ribbonwinder as shown in the figure.
4 Adhere the top end of theribbon to the paper core with adhesive tape. Turn
the ribbon winder in the direction ribbon winding to remove slackness and
wrinklesfrom the ribbon.
5 Press down theribbon bearin g flat 10 to closethe print head.
The open lever hook will lock.
6 Close the cover.
7 Turn on the power to the printer. The LCD screen on the control panel will
display "On line." Press the Feed key. The paper will advance to the next
label and stop there.
Ribbon
Print head opened
Roll paper
Ribbon
Direction of ribbon winding
Completion of setting paper and ribbon
11
12
13
1