4.3 Paper Feed Troubleshooting
Problem | Cause and remedy | ||
|
|
|
|
Paper doesn't | • Wrong paper path. | → | Use correct path. |
feed. | • Mechanism head is open. | → | Close the mechanism head. |
| |||
|
|
| |
Paper skews. | • Paper end is not in | → Slightly push the paper guide | |
| contact with the paper |
| against the paper end. |
| guide. |
|
|
| • Roll guide is not in | → | Slightly push the roll guide |
| contact with the roll |
| against the roll paper. |
| paper. |
|
|
| • Head pressure is not | → | Adjust it with the offset adjustment |
| correct. |
| screw according to the paper |
|
|
| width. |
|
|
| |
Paper doesn't | • Setting mode is not | → Check whether the setting mode | |
align with the print | correct. |
| is for paper gap or black line |
position. |
|
| sensor and if it is not, change it as |
|
|
| necessary. |
| • Paper gap (black line) | → Adjust the voltage of the paper | |
| sensor adjustment failure. |
| gap and black line sensor from |
|
|
| the voltage setting in the system |
|
|
| maintenance mode. |
| • Transfer data is abnormal. | → | If the contents of the transfer data |
|
|
| are incorrect, set them properly |
|
|
| again. |
|
|
|
|
