Citizen Systems CLP-6002, CLP-6001 user manual When fnnn command is executed while tear-off is OFF

•Initialization parameter values

Initialization values for print or tear position are described below by each operating mode.

In Native ON				Unit:	mm (inch)
	Normal	Auto-cutter	Peeling	Tear-off		Minimum
	print					value
Print position	55.9(2.2)					12.7(0.5)
(Onnnn, form offset)
Tear position	55.9(2.2)	86.3(3.40)	68.5(2.7)	73.5(2.9)		12.7(0.5)
(fnnn, feed offset)

If values lower than the minimum value are set, the initialization value will be set.

In Native OFF				Unit:	mm (inch)
	Normal	Auto-ı cutter	Peeling	Tear-off		Minimum
	print					value
Print position	27.9(1.1)					12.7(0.5)
(Onnnn, form offset)
Tear position	27.9(1.1)	58.3(2.3)	37.0(1.46)	42.1(1.66)		12.7(0.5)
(fnnn, feed offset)

If values lower than the minimum value are set, the initialization value will be set.

6.5.6When "fnnn" command is executed while tear-off is OFF

Even with the tear-off OFF, the paper will be fed to the "fnnn"-specified position after printing if an "fnnn > Onnnn" value is set by using the "fnnn" command.

This function can be used in such cases as another device is incorporated in the printer.

When operating with the FARGO, the following is different from those in the tear-off ON:

•The paper is fed immediately after printing, whereas, in the tear-off ON the paper is fed when no data is transmitted for 0.5 second after printing.

However, if the next print data is transmitted during printing, the printer will start printing without feed or back-feed.

6-18