Citizen Systems CT-S4000L, CT-S4000M, CT-S4000DC Partition for Paper Roll, Setting DIP Switch

3.5		Partition for Paper Roll
At the time of shipment, this partition is not installed.				Partition →
1.	Confirm that the power switch is OFF.
2.	Open the printer cover.
3.	Insert the partition into the slot and align it
	with the scale inside of the printer which
	meets the width of the paper roll used. When			Scales→
	using the 80mm or 82.5mm wide paper roll,
	set the partition by using the accessory screw.		58mm	80mm 82.5mm
	*58 mm is only for label supporting model.			Partition

4.Change the setting of paper width by reffering to the section 5.2, "Manual Setting of Memory

Switch".

CAUTION!

When using 112 paper roll, the partition is not used.

3.6 Setting DIP Switch

The DIP switch is present on the serial interface board.

The function of each switch is as shown below.

Interface board	DIP switch
mounting screws

CAUTION!

■As for the setting of the serial interface, it gives priority to the setting of the memory switch rather than the DIP switch as the factory default.

■Consult with the dealer where the printer was purchased when the change of the DIP switch setting is necessary.

Switch No.	Function	ON		OFF	InitialSettings
1	Communication condition	DIP switch setting	Memory switch		OFF
	setting method		setting
2	Hand shake	XON/XOFF	DTR/DSR		OFF
3	Bit length	7 bits	8 bits		OFF
4	Parity check	With parity	None		OFF
5	Parity selection	Even parity	Odd parity		OFF
6					OFF
	Baud rate selection	See Table below.
7					ON
8	INIT	Reset	Invalid		OFF

Selecting baud rate

Baud Rate (bps)		Switch No.
	6		7
2400	OFF		OFF
4800	ON		OFF
9600	OFF		ON
19200	ON		ON

38400, 57600 and 115200 bps can also be selected by a command, etc.

— 15 —