Citizen Systems CT-S4000DCM Installing the Printer, Anti-slip rubber feet for vertical setting

(1)Connector Pin Configuration

No.	Signal	Function
1	FG	Frame Ground
2	DRAWER 1	Drawer 1 drive signal
3	DRSW	Drawer switch input
4	VDR	Drawer drive power supply
5	DRAWER 2	Drawer 2 drive signal	6	1
6	GND	Common ground on circuits

Connector used: TM5RJ3-66 (Hirose) or equivalent

Applicable connector: TM3P-66P (Hirose) or equivalent

(2)	Electrical characteristics
	1)	Driving voltage: 24 VDC
	2)	Driving current: Approx. 1A max. (shall not exceed 510
		ms.)
	3)	DRSW signal: Signal levels: “L” = 0 to 0.5 V, “H” = 3 to 5 V
(3)	DRSW signal
	DRSW signal status can be tested with the DLE+EOT,

1

2

3

5V VDR

GS+a, or GS+r command or

at pin 34 on the parallel interface port.

(4) Drive Circuit (printer side)

VDR

4

5

6

CAUTION!

■No output is produced while printing.

■The cash drawers 1 and 2 cannot be driven simultaneously.

■A solenoid used for the cash drawer should be of 24 Ω or more. The output current should be kept at 1A or less; otherwise, breakdown or burning could occur.

3.4Installing the Printer

The printer can be installed horizontally, vertically, and on the wall. At the time of shipment, the printer is set for horizontal installation. To install the printer vertically or on the wall, the following adjustments are required.

1. Adjustment of paper near-end sensor position (See section 3.7)

2. Anti-slip rubber feet (for vertical setting)

3. Optional wall-mounting kit (for wall-mounting)

CAUTION!

Vertical position

■When used in vertical position, the printer ejects paper not to fall naturally even with full cutting. Be careful in using the printer built in equipment, etc.

■Ensure that the wall on which the printer is mounted has enough strength before installation.

■When using in horizontal setting, avoid cutting full. Otherwise, the cut paper may drop into the cutter and may result in double cutting and narrow pieces of paper. This may cause paper jam.

— 14 —