Citizen Systems iDP-460 user manual Drawer KICK-OUT Connector and Power Connector, Drive Circuit

iDP-460 User’s Manual

8. DRAWER KICK-OUT CONNECTOR AND POWER CONNECTOR

8.1Specifications of Drawer Kick-Out Connector (D-type Only)

(1)Drawer kick-out drive signal

The pulses specified by the BELL command(07h) are output.(Approx. 200 ms)

(2)Electrical characteristics

1)Drive voltage: 24 V DC

2)Drive current: 0.8 A at maximum

8.1.1Connector’s Pin Configuration

No.

Signal

Function

1	FG	Frame Ground
2	DRAWER	Drawer drive signal
3
4	VDR	Drawer drive power
5
6	GND	Common ground on the circuit
	Connector used		: TM5RJ3-66(HIROSE) or equivalent
	Applicable connector : TM3P-66P(HIROSE) or equivalent

CAUTION : • No output is made while printing.

•A solenoid used for the drawer should be of 36 Ω or more. An output current should be kept below 0.8 A. Otherwise, there is a danger of trouble or burnout.

•This connector cannot be connected to a telephone line. Do not connect other than the solenoid.

8.1.2Drive Circuit

40 CITIZEN