Sound Adjustment

●Adjustment items

FRONT-L (Front left) ➜ CENTER*1 ➜ FRONT-R (Front right) ➜ SURROUND-R (Surround right) ➜ SURROUND-L (Surround left) ➜ SUB-WOOFER*2➜

FRONT-L...

*1 “CENTER” is displayed only when “CENTER-SP” (page 48) is set to “ON”.

*2 “SUB-WOOFER” is displayed only when “SUB-WOOFER” (page 48) is set to “ON”.

4.Touch on the right of the display to adjust to the gain level.

•“SP-GAIN” can be adjusted within the range -10dB to +10dB.

5.Repeat steps from 3 to 4 to adjust the desired item.

6.Press the [SOUND] button to return to the original mode.

Adjusting the filter frequency

●SUB-W LPF (Subwoofer Low-Pass Filter) adjustment

This filter cuts the signals above the selected frequency value.

Each touch switches the frequency value as follows:

THROUGH ➜ 50Hz ➜ 80Hz ➜ 120Hz ➜

THROUGH...

Select the frequency that suits your subwoofer. Set to “THROUGH” if you use powered subwoofers with built-in low-pass filters.

1.Press the [SOUND] button.

2.Touch [FILTER].

3.Touch on the left of the display to select [HPF] or [SUB-W LPF].

4.Touchon the right of the display to select the frequency value.

•Select from THROUGH, 50Hz, 80Hz, or 120Hz.

5.Press the [SOUND] button to return to the original mode.

English

Filter frequency

You can set a filter frequency value best suited for your speakers.

•Depending on the settings for SPEAKER SELECT, filters (HPF or SUB-W LPF) that can be adjusted differ. In the table below, “YES” refers to the item you can adjust while “NO” refers to the item you cannot adjust.

SPEAKER

 

FILTER

SELECT

HPF

 

SUB-W LPF*

Dolby PL II

No

 

Yes

NORMAL

Yes

 

Yes

 

 

 

 

*This item can be adjusted only when “SUB- WOOFER” is set to “ON”.

•The factory default setting for FILTER is “THROUGH”.

Filter adjustment

●HPF (High-Pass Filter) adjustment

This filter cuts the signals under the selected frequency value.

Each touch switches the frequency value as follows:

THROUGH ➜ 50Hz ➜ 80Hz ➜ 120Hz ➜

THROUGH...

Select the frequency that suits your speaker when you have installed speakers with smaller diameter.

Set to “THROUGH” if you use speakers that can reproduce low frequency sound.

Setting the music mode

MUSIC mode

If you set Dolby Pro Logic II to “MUSIC”, you can further adjust the MUSIC mode in detail.

•This is available only when “MUSIC” has been selected.

•The factory default settings are “NO” for

“PANORAMA”, “3” for “DIMENSION”, and “3” for “CTR WIDTH”.

Adjustment items

●PANORAMA (Panorama control setting) Extends the front sound field image to rear speakers. Set to “YES” if you think the surround effect is not enough.

●DIMENSION (Dimension setting)

Shifts the sound field image to either front or rear. Set this item if the sound field image is weighted on either front or rear side.

The center adjustment value is 3. Select from 0 to 2 for weighting on the rear side. Select from 4 to 6 for weighting on the front side.

●CTR WIDTH (Center width setting) * Distributes a part of the center speaker sound to front speakers (left and right).

By distributing the center sound to front speakers, the entire sound field image, and you can feel the natural broadening of the sound field image.

DXZ958RMC 41