English |
| Basic Operations | |
| Opening and turning the display | ||
|
| ||
|
|
| |
|
| WARNING | |
|
| • To prevent the battery from going dead, | |
Owner’s | |||
| operate this unit with the engine | ||
|
| ||
|
| running, if possible. | |
manual |
| • When the liquid crystal panel is operating, | |
| caught between the panel and main unit | ||
|
| be careful not to get your hand or finger | |
|
| or the instrument panel of the car. | |
| |||
|
|
|
Standing up the liquid crystal panel
1.Press the [OPEN] button and the liquid crystal panel comes out and stand up automatically.
∗While the liquid crystal panel is opening or closing, the LED of the [FUNC] button blinks.
Note:
•If the liquid crystal panel stops in the middle of its operation, press the [OPEN] button to house the panel and press the button again to stand it up.
The unit enters the same display mode as the display was turned off the last time.
Adjusting the angel, etc. of the liquid crystal panel
The angle of the liquid crystal panel or protruding amount of the panel from the mounting surface can be adjusted depending on the mounting angle of the unit or light coming into the car.
●To adjust the angle
1.Every time the [TILT] button is pressed, the liquid crystal panel tilts forward or backward at up to about 20 degrees. The adjusted angel is stored in memory.
˚ | 20 | ˚ | |
20 |
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
Note:
•Do not move the liquid crystal panel by hand.
●To adjust the slide position
1.Press and hold the [TILT] button and release when a beep is heard.
The liquid crystal panel slides forward or backward. The adjusted slide position is stored in memory.
*There are 3 adjustable positions available on
this panel.
Housing the liquid crystal panel
1.Press the [OPEN] button and the liquid crystal panel is housed automatically.
Note:
•When leaving this unit unused for a long period of time or leaving your car, be sure to house the liquid crystal panel into the main unit.
22 VRX935VD
