Initial Setup, English, 3.Conﬁgure your ampliﬁer

ENGLISH

Important:

conﬁguring balanced/ single-ended operation

Initial Setup

Your new Classé ampliﬁer is quite simple to set up and enjoy. Please follow the steps outlined below in order to safely set up and use your new ampliﬁer.

The AC mains connection should be the last connection you make on your new power ampliﬁer. In addition, it is always a good idea to power up your power ampliﬁer(s) last, after everything else has been powered up and has stabilized. .

Conversely, it is good practice to power the ampliﬁer(s) down ﬁrst when shutting down the system, as this prevents any transients from other components from getting through to your loudspeakers.

1.Unpack everything according to the included instructions. Be careful when doing so, as this ampliﬁer is quite heavy.

2.Place your ampliﬁer (be sure to read “Unpacking and Placement”) and connect it to the AC mains.

This includes deciding on the location, making sure you have adequate ventilation, and adequate clearance for all the wires behind the ampliﬁer. Once accomplished, connect the ampliﬁer directly to the AC mains. Do not use extension cords, as most are not suitable for the current sometimes required by your ampliﬁer.

3.Conﬁgure your ampliﬁer.

The Select and Mode buttons are used when conﬁguring your ampliﬁer for how you would like it to operate.

While in standby, pressing the Select button will cause the Channel LEDs to light up, indicating how the ampliﬁer is currently conﬁgured (either balanced or single-ended) for each channel.

One of the Channel LED indicators will be blinking, indicating that you may select either balanced or single-ended operation for that channel. Press the Mode button to toggle between either the balanced mode or the single- ended mode of operation, as indicated by which of the two channel LEDs for that channel is blinking.

Press the Select button again to select the next channel, and repeat the pro- cess until the ampliﬁer is conﬁgured as you desire. To ﬁnish, continue to press and release the Select button until all the Channel LEDs are off.

Make sure you conﬁgure the ampliﬁer to use the type of input connection you will be using for each channel. You may safely use any combination of single-ended and balanced input connections your system requires.

Classe Audio CA-5100 owner manual Initial Setup, English, 3.Conﬁgure your ampliﬁer

Models: CA-5100

Initial Setup

3.Conﬁgure your ampliﬁer.