Clover Electronics CDR 0440 Frame Rate, Quality, Recording, Electric Light, Control, PRE Record

for all channels.

(FRAME RATE, QUALITY, RECORDING, PRE REC, POST EVT REC)

FRAME RATE	Set the frame rate for the specified channel. The sum of the frame rate
	values from each channel cannot exceed the maximum frame rates for a
	specific recording resolution.
	Typical values of the maximum frame rate for video are
	120/100 fps version
	120/100fps: 352*240(NTSC)/352*288(PAL)
	60/50fps: 704*240(NTSC)/704*288(PAL)
	30/25 fps: 704*480(NTSC)/704*576(PAL)
QUALITY	Select the recording quality for the specified channel. Options are:
	Network, Standard, High, Superior and Ultra.
RECORDING	Assign the recording mode for each channel. Options are: Continuous, By
	Motion, By Sensor, By Schedule or Disable.
ELECTRIC LIGHT	Enable/Disable electric light control. When alarm output is connected to an
CONTROL	electric light for the motion detection signal, user needs to set ELECTRIC
	LIGHT CONTROL to ON. Then the motion detection signal will not be
	activated for 2-3seconds after alarm output is turned off.
SENSOR RECORDING	Enable setting up to 4 sensors of 9 sensors for the specified channel using
	the control button ( Ÿ ź).
PRE RECORD	Enable/disable pre-event recording. Pre-event recording time is 3 seconds
	and only intra-frames are recorded for pre-event recording.
POST EVENT RECORD	Set the post event recording time duration for the specified channel. (10-
	30 seconds)
AUDIO	Enable/disable audio recording for the specified channel.
	z Fixed-available on only from channel 1 to channel 4.
SCHEDULE	Set the recording schedule. Press SEL to go to schedule setup screen.

25