Clover Electronics CDR 4170 instruction manual Camera BNC PTZ Camera

8.2 CAMERA

This product can be installed up to 4 cameras.

Connect cameras to the VIDEO IN (BNC) on the back panel of the product.

To connect a PTZ camera, connect the PTZ camera’s control line to the RS-485 (+, -) terminal and connect the video output to one out of VIDEO IN on the back panel of the product.

CAMERA (BNC)

PTZ CAMERA

		VIDEO IN	V - OUT1	A - IN
CH1	CH2	CH3	CH4
	LOOP OUT		V - OUT2	A - OUT

ALARM IN

1 2 3 4 GND

ETHERNET

ALARM OUT			CLOVER
						AC INPUT
			ELECTRONICS U.S.A
			MODEL NO : CDR4170	C R	US LITED
	_		AC100-240V,50/60Hz, 25W
+					E233232
			CLOVER ELECTRONICS	AUDIO/VIDEO EQUIPMENT 2UW2		POWER
RS485			Factory ID/DHHS CODE : BC
			13073 EAST 166TH STREET, CERRITOS, CA 90703
		CAUTION		ATTENTION
	RISK OF ELECTRONIC SHOCK			RISQUE DE CHOC ELECTROIQUE
		DO NOT OPEN		NE PAS ENLEVER		AC100-240V,50/60Hz

NOTE

A LOOP OUT is a looping output trough VIDEO IN. Therefore the monitor for looping output can be used only when there is video signal on the VIDEO IN.

8.3 AUDIO

The system has one channel audio input and output. If you wish to record and playback audio signal, connect the proper audio device (microphone) to the AUDIO IN (1 Vp-p @600 ohms) and speaker to the AUDIO OUTPUT (See illustration below).

- 41 -