Operating Your Radio
Setup Mode Programming
Setup Mode Programming
•
The following series of procedures is designed to allow you to set the programmable features of your radio. Correctly following these steps results in a minimal amount of radio setup programming time.
NOTE
When in the Setup mode, if you stop programming for longer than 15 seconds, your entry will be saved and the radio will go back to the Marine Standby mode. When you return to Setup mode and continue programming, you will see the last “value” displayed. While in the Setup mode, you will not receive any signal reception.
Marine (VHF) Mode Programming
Programming these features will allow you to customize certain features of this radio to enhance your
Start from Marine Standby mode to begin Marine (VHF) Setup programming. Press and hold the Call/Enter/Setup button for two (2) seconds to enter the programming mode.
Set Channel Map | International/Canada/USA Channel Maps |
Active Channel Map Icon
Channel Up/Down Button
Three (3) sets of VHF Channel Maps have been established for marine use in the USA, Canada, and the rest of the world (International). Most of the channels are the same for all three (3) maps, but there are definite differences (see table on pages 16 through 23). Your radio has all three (3) maps built into it and will operate correctly in whichever area you choose.
To Set Channel Map Operating Area:
1.The Channel Map mode is the first mode that begins the Marine (VHF) Setup programming.
2.U, I and C will display, with the current setting (the I icon is the default) flashing.
3.Press Channel Up/Down button to select the I, C or U icon.
4.Press Call/Enter/Setup button to save this entry and move to the next setup programming mode.
NOTE
One (1) or two(2) of the channel maps might have been disabled for sales of this radio in some countries.
36 English
