F80 Installation.qxp:QXP-1058720374.qxp 12/29/06 10:03 AM Page 40

Introduction

Getting Started

Standby and Receive

Standby Mode

Channel Select Knob

SELECT

MEM

Mic Channel Buttons

Channel 16/9 Button

WX/Enter Button

Standby mode is the usual mode for the radio whenever it is turned On.

From Standby Mode, You Can:

Change your radio’s settings using setup routines.

Receive messages on the current channel as well as DSC messages.

Receive NOAA alerts if Weather Alert mode is turned On.

Switch to Transmit mode using the Talk button.

While the radio is in Standby mode, the Receive mode is entered whenever a strong enough signal to break squelch is sent to the radio. You will hear the message through whichever speakers are connected to the radio.

To Change the Channel You Are Listening to, You Can Choose One of the Following:

1.Turn the Channel Select knob clockwise for higher VHF channel. Turn the Channel Select knob counterclockwise for lower VHF channel.

2.Press Channel Up/Down buttons on microphone to go to the next higher or lower VHF channel. For rapid advance, press and hold the Channel Up/Down button.

3.Press the Channel 16/9 button. This will take you to Channel 16 with one (1) press and to Channel 9 with a second press. Additional presses will toggle between Channels 16, 9 and original channel.

4.Press the Weather/Enter button. This will allow you access to the weather channels. Turning the Channel Select knob or pressing the Channel button on the microphone allows you to change weather channels.

5.Press the Tri-Watchbutton to monitor three (3) Channels 16, 9 and one user selectable channel.

Tri-Watch Button

40 English

Page 43
Image 43
Cobra Electronics Mrf 80b owner manual Standby and Receive, From Standby Mode, You Can