Code Alarm CR3 manual Bluetooth Radio Operation, Example Reset to RF Factory Defaults QuickConnect

1.7 - Bluetooth Radio Operation

1.7.1 - Introduction

This CR3 features a Bluetooth® wireless radio. The radio allows for point-to-point wireless communica- tion with other Bluetooth devices that support serial port protocol (SPP). The following guide will give you general instructions on connecting your CR3 to a desktop or laptop computer with a Bluetooth radio.

Connecting With A QuickConnect Code

The easiest way to connect to a Bluetooth device is to visit the Code website and create a QuickConnect Code that is specifi c to your device (Figure 1.13). This code will link your CR3 directly to the desired Bluetooth device. To create a QuickConnect Code, you will need to know the Bluetooth address (often referred to as the BD_ADDR) of that device. You can usually fi nd the 12-character Bluetooth address somewhere on the device near the device’s serial number (see Figure 1.14).

Figure 1.13 Figure 1.14

If you purchased a CodeXML Bluetooth Modem or a Belkin® Bluetooth adapter from Code or from an authorized distributor, a QuickConnect Code was included. If you bought a Bluetooth adapter separately and wish to create a QuickConnect Code, please visit Code web site at:

http://www.codecorp.com/support/bdaddr.php.

Important Note: While installing the Bluetooth Confi guration Manager software that was included with your Bluetooth adapter, make sure to note the Communication Port number the software assigned for the adapter (e.g. COM 10). This is the COM Port your CR3 will connect through.

To connect your reader, scan the Reset to Factory Defaults below then the QuickConnect Code and your CR3 will automatically connect. You should also scan the Save Settings code if you want to save these settings. (Note: If the CR3 unit powers off without scanning the Save Settings code, you will lose your settings.)

	Example:
Reset to RF Factory Defaults	QuickConnect	Save Settings

Save Settings C002332_09_CR3 User Manual - 14