Rack-Mount Brackets | Compatible Systems A00-1869, Enterprise-8

Chapter 2 - Mounting Instructions

8

Rack-Mount Brackets

Figure 3. Rack-Mount Brackets

Brackets (shown in Figure 3) are provided for mounting the IntraPort Enterprise-8 in a stan- dard 19-inch equipment rack or a Telco rack. Note that the left bracket features a fold-down shelf which maintains the proper alignment of the brackets in the rack, but does not bear the weight of the unit. The ledges at the bottom of the brackets bear the weight of the unit until it is securely attached to the equipment rack. You will need to provide your own screws or clips to fasten the brackets and mounting ears to the equipment rack.

Image 14

Compatible Systems A00-1869, Enterprise-8 manual Rack-Mount Brackets

Contents

IntraPort Enterprise-8 VPN Access Server Installation Guide Page Command Line Management Network InstallationCompatiView Software Installation Introduction to the IntraPort Enterprise-8 LED Patterns and Test Switch Settings Basic Configuration GuideShipping Defaults Appendix a Connector and Cable Pin Outs Appendix F Terms and Conditions Iii Location of Voltage Switch on the Power Supply IntraPort Enterprise-8 Installation Overview Introduction to the IntraPort Enterprise-8 IntraPort Enterprise-8 Manual Overview Few Notes Warranty and ServiceGetting Started Please Read the Manuals Supplied with the IntraPort Enterprise-8 Additional Items Needed for InstallationWhat You Will Need to Get Started Mounting Instructions Placement ConsiderationsSafety Guidelines Changing the Power Supply Voltage Settings Parts and Tools Installing Mounting Ears and Handles Installing Mounting Ears for a Telco Rack Rack-Mount Brackets Rack-Mount Brackets Right Bracket Installation Fastening the Right Bracket to the Rack Left Bracket Installation Fastening the Left Bracket to the Rack Securing the Shelf Lowering the Shelf Moving the Unit into the Rack Moving the Unit into a Standard Equipment Rack Placing the Unit in an Equipment Rack Placing the Unit in a Standard Equipment Rack Securing the Unit to the Rack Securing the Unit to the Rack Network Installation Physical Connection Requirements Connecting the Server to the Ethernet Detail of Riop Cards Power Alarm Information Connecting a Management ConsolePowering Up the Server CompatiView for Windows CompatiView Software InstallationInstallation and Operation System Requirements Transport Protocols and CompatiView Command Line Management Out-of-Band Command Line Management Setting Up Telnet Operation IP Settings for Setups in Parallel with a Firewall Basic Configuration GuideEthernet Interface Configuration IP Protocol IP Settings for Setups Behind a Firewall AppleTalk Protocol Configuring the Server for LAN-to-LAN TunnelsIPX Protocol Suggested for Client Tunnel Configurations Configuring the Server for IP and IPX Client TunnelsRequired for Client Tunnel Configurations VPN User Database Radius Server User Authentication Settings Setting up Radius AuthenticationSetting the IntraPort Enterprise-8 for a Radius Server ACE/Server Settings Setting up SecurID AuthenticationSetting the IntraPort Enterprise-8 for an ACE/Server Saving a Configuration File to Flash ROM Ethernet Interfaces Shipping DefaultsDefault Password IntraPort Enterprise-8 LED Patterns IntraPort Enterprise-8 Switch Settings Appendix a Connector and Cable Pin Outs Pin Outs for DB-25 Male to DB-25 Female Console Cable Appendix B Downloading Software From Compatible Systems Appendix C Security Dynamics ACE/Server Information Appendix D Adding or Replacing Riop Cards Removing and Replacing an Riop Card or Cover Plate Appendix E When the Over Temp Light Comes On Replacing or Cleaning the Intraport Enterprise-8 Air Filter Appendix F Terms and Conditions Appendix F Terms and Conditions