CHAPTER 8 - BIOS Setup
SPI-8450-LLVA 109
PLEASE RUN EISA CONFIGURATION UTILITY
The EISA non-volatile RAM checksum is incorrect or cannot correctly read the EISA slot. This
can indicate either the EISA non-volatile memory has become corrupt or the slot has been
configured incorrectly. Also be sure the card is installed firmly in the slot.
EISA configuration is not complete
PLEASE RUN EISA CONFIGURATION UTILITY
The slot configuration information stored in the EISA non-volatile memory is incomplete.
Note: When either of these errors appear, the system will boot in ISA mode,
which allows you to run the EISA Configuration Utility.
Error encountered initializing hard drive
Hard drive cannot be initialized. Be sure the adapter is installed correctly and all cables are
correctly and firmly attached. Also be sure the correct hard drive type is selected in Setup.
Error initializing hard disk controller
Cannot initialize controller. Make sure the cord is correctly and firmly installed in the bus. Be
sure the correct hard drive type is selected in Setup. Also check to see if any jumper needs to be
set correctly on the hard drive.
Floppy disk controller error or no controller present
Cannot find or initialize the floppy drive controller. Make sure the controller is installed
correctly and firmly. If there are no floppy drives installed, be sure the Diskette Drive selection
in Setup is set to NONE.
Invalid EISA configuration