CHAPTER 6 - RAID Controller
54 SPI-8450-LLVA
6.3.3 Windows NT 4.0
Installing Driver During New Windows NT Installation
Note: Before the Windows NT4.0 installing, please copy the whole files and folder in the folder
as follows “RAID\WinNT4\”of the Driver CD-ROM to a floppy disk.
1. Start the system installation by booting from the Windows NT disk.
1.1. Floppy install: boot the system with the Windows NT installation diskettes.
1.2. Floppyless install: boot from floppy and type “WINNT /B”. After files have been
copied, the system will reboot. On the reboot, press the [F6] key when the message
“setup is inspecting your computer’s hardware configuration …” appears.
1.3. CD-ROM disk install: boot from the CD-ROM disk and press the [F6] key when the
message “Setup is inspecting your computer’s hardware configuration … “ appears.
2. When the “Windows NT Setup” window is generated, press “S” to specify an additional
device.
3. Press “O” to select “Other” and press the [Enter’ key.
4. Insert the RAID controller driver diskette into drive A: and press the [Enter] key.
5. Choose “Win NT Promise FastTrak100-Lite(tm) Controller” from the list that appears on
screen, and press the [Enter] key.
1. The Windows NT Setup screen will show again “Setup will load support for the following
mass storage devices”. The list will include “Win NT Promise FastTrak100-Lite™
controller”.
Note: If you need to specify any additional devices to be installed, do so at this time. Once all
devices are specified, continue to next step.
7. From the Windows NT Setup screen press the [Enter] key. Setup will now load all device
files and then continue the Windows NT installation.
8. After a successful installation, the “SCSI Adapter Setup” box will show that the “Win NT
Promise FastTrak100-Lite™ Controller” driver has been installed.