CHAPTER 6 - RAID Controller
SPI-8450-LLVA 55
Installing Driver with Existing Windows NT System
WARNING: If you plan to move your boot drive to a mirrored RAID 1 array, hard drives should NOT be
connected to the RAID connectors before performing the following procedure. The RAID
controller drivers must be loaded on the system hard drive (running under the existing hard
drive controller) before any hard drives are connected to the RAID connector.
1. Choose “Settings” from the “Start” menu.
2. Choose “Control Panel” from the “Settings” menu.
3. Double-click on the “SCSI Adapters” icon, which generates the “SCSI Adapters” dialog
box.
4. Choose “Drives”, and then press “Add”.
5. In the “Install Divers” dialog box, pres “Have Disk …”
6. When the “Install From Disk” appears, insert the RAID controller diskette in drive A:
7. Type “A:\NT4” in the text box window, then choose “OK”.
8. When the “Install Driver” dialog box appears, select “Win NT Promise FastTrak100-Lite
Controller” and then press “OK”.
9. When the “Select SCSI Adapter Option” dialog box appears, press “Install”.
10. After a successful installation, the “SCSI Adapter Setup” box will show that the “Win NT
Promise FastTrak100-Lite Controller” has been installed.
11. Power off our system.
12. If moving the boot drive to the FastTrak100-Lite, now attach the hard drives otherwise
reboot.
Removing the Driver from Windows NT 4.0
1. In “Start” button choose “Control Panel” in “Setup” group.
2. In “Control Panel”, select “SCSI Adapter”, next choose “Drivers” label
3. Choose “Remove” button.
4. After successful removing, the “SCSI Adapter Setup” box will show that “Win NT
FastTrak100-Lite RAID Controller” has been removed.