Cornelius CR1400, IAC 322, IAC227 Plumbing Connections, Electrical, Installation Check Points

Electrical Service	Electrical Service
Line	Line
Manual Disconnect	Manual Disconnect
Switch
	Switch
Shut-Off	Shut-Off Valve
Valve
Water Filter	Water Filter
STRAIN RE-	Shut-Off Valve
LIEF
MUST BE	Condenser Water Inlet
USED

Dump

Strain Relief

Valve

must be used

Bin Drain

Tube

AIR-COOLED MODELS

Drain Tube

Dump Valve

Drain Tube

Condenser Water

Drain Tube

Floor	Floor
Drain
	Drain

Bin Drain

Tube

WATER-COOLED MODELS

Note: Leave all panels on the cuber until it is in place on the bin.

PLUMBING CONNECTIONS

1.All plumbing lines and connections must conform to local and national plumbing codes.

2.Line shut-off valves must be located in supply water lines for cuber and condenser if product is water- cooled. Water supply to water-cooled condenser must include a stand-pipe to prevent “water hammer”.

3.Should your local water supply quality require the installation of a water filter system, consult your local dis- tributor or dealer for proper size required.

4.Water supply pressure must not be lower than 20 PSI (1.37 BAR), nor should it exceed 120 PSI (8.16 BAR).

NOTE: Water filters larger then 5 microns do not give proper protection. Water pressures above 80 PSI (5.44 BAR) will destroy the filter.

DRAIN LINES: Bin and cuber drain lines must never be connected together and must be vented.

NOTE: All HP-62 (R404A) ice machines have a voltage range of –5%, +10% from the serial palte rating.

ELECTRICAL

1.All wiring and connections must conform to national and local electrical codes.

2.Wire size and circuit protection must conform to specifications and cuber must be on a separate electrical circuit.

3.Strain relief connectors must be used at the junctions box of the control box and the cuber.

4.Cuber must be grounded by the control box ground screw or other method for intentional safety grounding that meets code requirements.

5.A manual disconnect in a convenient location to the cuber must be installed.

INSTALLATION CHECK POINTS

1.Has bin and cuber been leveled and sanitized?

2.Does electrical and plumbing meet code requirements?

3.Check correct operating water level in the water pan.

166240004 14

12/1/94 Rev 3/4/96