MODEL 113.24821 O, 113.248320,
1113.248440
ATTACHING LEG SET
From the loose parts bag find the following hardware:
Item | Description |
| Qty. |
A | Truss Head | Bolts 1/4.20x 1/2 | 32 |
B | Lockwashers | External 1/4 | 32 |
C | Hex Nuts | 32 | |
From the loose parts find the following items:
D | Leg Channel | 1 |
E | Legs (with attached support brackets | and |
| leveling feet) | 4 |
F | Lower Stiffeners | 4 |
_*NOT SHOWN TO SCALE
|
| Switch |
|
|
|
|
|
|
| =_ont |
|
|
|
1. Lay a piece of cardboard on the floor to keep from | Side | ,/_/_J_//_1 __.Front Leg | s Are | |||
|
|
|
|
|
| |
scratching the saw. |
|
|
|
|
|
|
2. Position the basic saw assembly on the floor as |
|
|
|
|
|
|
shown below. The back cabin et of the saw should be |
|
|
|
|
|
|
laying flat on the floor. It may be necessary to have | t__._ | t | _ | _ |
| Leg |
someone help you lift the saw. |
| |||||
Artac bed | Here | |||||
|
| J[ | t_'/ \ | Rear | Legs Are | |
|
| L_._/_Attached_ | __ | _ | Here | |
|
|
|
| \ Floor |
| |
3.Mount the two front legs to the basic saw assembly using truss head bolts, Iockwashers, and nuts. Make sure that the four (4) holes in each corner of the saw line up with the four (4) holes in the top of each leg. At this time only put bolts through thesides
of the saw assembly notthe front. Onlyfinger tighten nuts.
4.Position the leg channel inside the legset as shown. Fasten the channel piece, leg, and saw together with two (2) truss headbolts on each side. The threaded section of the bolts should point towards the inside of the basic saw assembly. Put a lock- washer and hex nuton each bolt. Finger tighten nuts at this time.
SAW
BAS E
LEG
!
TRUSS
HEAD
SCREW
LOCKWASHER
Trusshead screw, Iockwasher, hex nut, and front channel piece.
12
