ADJUSTING FRONT TABLE
1.Adjust the front table so it is the same height asthe
rear table asfollows:
a, Lay a straight edge across front table to rear
table.
b. Gentlytap the fronttable down untilit isin line with
the rear table,
c. Tighten thePhillips head self tapping screw once
the front table isin the correct position.
d. If necessary adjust the two (2) oval point set
screws (see Step3) as needed to help lineup the
table.
e. Both the left and right sides of the front table
should be adjusted simultaneously.
TABLE LEVELING
SETSCREWS
2, To keep the miter gage grooves in line, use a flat
blade screwdriver against the head of one ofthe low
head capscrews in the miter gage groove to force
the table alignment key firmly forward intothe notch
in the front table.
3. While holding the alignment key into the notch,
tighten theother capscrew. Removethe screwdriver
and tighten the remaining screw. Check that the
miter gage grooves line up,
4. Check the operation of springs and tabs by remov-
ing the front table and reinstalling. Removethetable
by lifting up on two spring tabs under front edge of
the table until springs are free, then pulling forward.
33