ALL MODELS

INSTALLING THE BLADE

WARNING: TO AVOID INJURY FROM ACCIDENTAL STARTING, MAKE SURE THE POWER CORD IS UNPLUGGED BEFORE REMOVING ANY PART FROM THE SAW.

1.Remove the blade guard by loosening the two (2) mounting screws with a phillips screwdriver and lifting the blade guard upward.

2.Loosen the upper blade guide assembly and lower to approximately 3 inches above rear table and retighten lock knob. This is necessary to make adjustments to blade guide and back up roller bearing.

3.Loosen the two capscrews that lock the upper blade guides using a 1/8-inch hex "L,'wrench and separate them about 1/8-inch. Repeat the same step for the lower blade guides.

.IGNUGARD

_.j

LOCK KNOB

Jrt[,t] I

BLADE GUIDE

CAPSCREWS

26

Page 26
Image 26
Craftsman 113.248510 owner manual Jrt,t, Installing the Blade