MODELS 113.248320,113.248440, and113.248510
4. Locate the correct motor pulley(Model 113.248210
hasa "one-step" pulley). Placethe shaftkey intothe
groove on the motor shaft. Align the groove in the
pulley with the shaft key and install the motor pulley
onthe motor shaft with the setscrew bosstoward the
motor.
ALL MODELS
5. Place the Poly "V" belt into the motor mount as
shown on the underside of the band saw.
6. Look atthe motor mount and find the slotthat isnar-
rower than the other three. When mounting the
motor,the motorstud without a spacer goes into this
slot.
MOTOR MOUNT
NARROW
SLOT
7. Carefully position the motorsothat the poly"V" belt
is around the motor pulley and the four motor studs
align with theslots in the motor mount.
8. Push motor studs through and install the flanged
lock nuts tothe three (3) motor studs with spacers.
Start the flanged nuts byhand only at this time.
MOTOR MOUNT
9. Install the threaded stud through the hole in the
lowerleg of themotor mount and over themotor stud
asshown.
MOTOR MOUNT
THREADED STUD
18