ALL MODELS
CONNECTING THE MOTOR
1.Next, the motor cord needs to be wired into the motor. Coming from the underside of the table will be a cord with a black, white and green wire. This is the motor cord.
WARNING: FOR YOUR OWN SAFETY, NEVER PLUG I_HE SAW IN UNTIL ALL ASSEMBLY
STEPS ARE COMPLETED.
2.Loosen the two screws holding the connector box cover on the back side of the motor. Swing the cover open.
3.Install the green ground wire by removing the
green grounding screw and inserting it through the round metal terminal on the green ground wire of the motor cord. Reinstall the green screw into the hole from which it was removed and tighten securely.
WARNING: TO AVOID ELECTROCUTION,
NEVER CONNECT ANYTHING BUT THE
GROUND WIRE (COLORED GREEN) TO THE GREEN SCREW.
4.Insert terminal end of WHITE wire on spade terminal marked T4 on the motor. Push terminal
firmly until seated.
5.Insert terminal end of BLACK wire on spade terminal marked T1 on the motor. Push terminal
firmly until seated.
6.Close motor connector box being sure that power cord is seated in the largest strain relief groove and tighten box cover screws.
7.DQ NOT plug in power cord.
TERMINAL
GREEN
BLACK WIRE
TERMINAL Tt
GREEN WIRE
.TO GREEN SCREW
STRAIN RELIEF
WtRE TO
TERMINAL T4
2O
