Craftsman 315.2121O0 owner manual General, Extension Cords, Lubrication

WARNING:Whenservicing,usaonlyidentical

CraftsmanreplacementpartsUseofanyother.

partmay create a hazard or cause product damage.

GENERAL

Avoid usingsolvents when cleaning plasticparts. Most plasticsare susceptibleto damage from vadous types of commercial solventsand may be damaged by their usa. Usa clean clothsto remove dirt, carbon dust, etc.

,_ WARNING: Do not at any time let brake fluids,

gasoline, petroleum-basedproducts, penetrating oils, etc. come in contact with plastic parts. They containchemicals that can damage, weaken or destroyplastic.

it has been found that siectric toolsare subjectto accelerated wear and possiblepremature failure when they are used on fiberglass boats, sports cars, wallboard,spacklingcompounds, or plaster. The chips and gdndingsfrom these matedals are highly abrasiveto siectdc tool parts such as bearings,

brushes,commutators, etc. Consequently, it is not recommendedthat this tool be used for extended

work on any fiberglass material, wallboard, spackling compounds,or plaster. During any use on these matedais it is extremely importantthat the tool is cleaned frequentlyby blowingwith an air jet.

LUBRICATION

All of the bsadngs in this tool are lubricatedwith a sufficientamount of high grade lubricantfor the life of the unit under normal operating conditions.Therefore, no further lubricationis required.

EXTENSION CORDS

The usa of any extensioncord will cause some loss of power. To keep the loss to a minimumand to prevent tool overheating, usa an extension cord that is heavy enoughto carry the current the tool will drew.

A wire gage size (A.W.G.) of at least 14 is recom- mended for an extension cord 25 feet or less in

length.When workingoutdoors,usa an extension cord that is suitable for outdoorusa. The cord'sjacket will be marked WA.

_ cuttingCAUTION:areaandKeeppositionextensi°nthecordScordsoaWaythatfromitwillthe not get caught on lumber,tools, etc., dudng cutting operation.

WARNING: Check extension cords before each usa. If damaged, replace immediately.Never usa

tool with a damaged cord since touchingthe damaged area could cause electdcal shock resulting in sedous injury.

_k WARNING: Always wear safety gogglesor safety glasses with side shields dudngpower

tooloperation or when blowing dust. If operation is dusty,also wear a dust mask.

27