Craftsman 315.2121O0 owner manual See Figures 17, Viewofblade Squarewithfence Fence

•Usingan6mmkey,loosenthesockethead screwssecuringthefenceSee. Figure 16. Adjust

the fence left or right until the framing square and zero clearance throat plata are parallel.

•Retightenthe screws securely and recheck the fence-to-table alignment.

6 mmSOCKETHEAD	6 mmSOCKETHEAD
SCREW(S)	SCREW(S)

FENCE

MITER FRAMING

TABLE SQUARE

MITER

LOCKHANDLE

Fig. 16

SQUARING THE SAW BLADE TO THE FENCE

See Figures 17- 20.

•Unplug your saw.

VIEWOFBLADE

SQUAREWITHFENCE

FENCE

Fig. 17

_l, WARNING: Failure to unplug your saw could resultin accidental startingcausing possible

sedous personal injury.

Pull the saw arm all the way down and engage the lock pin to hold the saw arm in transport position.

Loosen the miter lock handle approximately one-half turn.

Depress the miter lock prate and rotate the miter table until the pointer on-the control arm is positioned at 0 °.

Release the miter lock plate and securelytighten the miter lock handle.

Lay a framing square flat on the mitertable. Place one leg of the square against the fence. Slide the other leg of the square against the fiat part of saw blade.

Note: Make sure that the square contacts the flat part of the saw blade, not the blade teeth.

MITER FRAMING

TABLE SQUARE

VIEWOFBLADENOTSQUAREWITH

FENCE,ADJUSTMENTSAREREQUIRED

Fig, 18

FENCE

BLADE

MITER FRAMING

TABLE SQUARE

VIEWOFBLADENOTSQUAREWITH FENCE,ADJUSTMENTSAREREQUIRED Fig. 19

16