•Theedgeofthesquareandthesawbladeshould beparallelasshowninfigure17.
•If the frontor beck edge of the saw blade angles
away from the square as shown in figures 18 and 19, adjustments are needed.
•Using the 8 mm hex key provided, loosen the socket head screws that secure the mounting
bracket to the miter table. See Figure20.
8 mmSOCKET
Loosen bevel lock knob and set saw arm at 0"
bevel (blade set 90" to miter table). Tighten bevel lock knob.
Place a combinationsquare against the miter table and the fiat part of saw blade,
Note: Make sure that the square contacts the flat part of the saw blade, not the blade teeth.
Rotate the blade by hand and check the
The edge of the square and the saw blade should be parallel as shown In figure 21.
FENCE
MITER
MOUNTINGTABLE 8 mmHEXKEY BRACKET
WRENCHFig. 20
•Rotate the mounting bracket left or right untilthe saw blade is parallel with the square.
•Retighten the screws securelyand recheck the
SQUARING THE BLADE TO THE
MITER TABLE
See Rgures 21-24.
•Unplug your saw.
COMBINATION
MITER SQUARE
TABLE
MITER
LOCKHANDLE
CORRECT_EWOFBLADE
SQUAREWITHMITERTABLE
Fig. 21
•If the top or bottomof the saw blade angles away from the square as shown in figures 22 and 23, adjustmentsare needed.
FENCE
_lb WARNING: Failure to unplugyour saw could result in accidental starting causing possible
sadous personal injury.
• Pull the saw arm all the way down and engage |
the lock pin to hold the saw arm in transport |
position. |
COMBINATION
• | Loosen the miter lock handle approximatelyone- |
| half tum. |
• | Depress the miter lock plate and rotate the miter |
TABLE
SQUARE
table untilthe pointer on the controlarm is posi- |
tioned at 0 °, |
• _ Release the miter lock plate and securelytighten |
the miter lock handle. |
VIEWOFBLADENOTSQUAREW111tMITER
TABLE,ADJUSTMENTSAREREQUIRED
Rg. 22
17
