Creative 1212M, 1820M owner manual Installing the E-MU 1010 PCI Card, Slo ts

2 - Installation

Installing the E-MU 1010 PCI Card

Installing the E-MU 1010 PCI Card

Note: This installation is very simple but if you are not familiar with the installation of computer peripherals and add-in boards, please contact your authorized E-MU Systems dealer or an approved computer service center to arrange for the installation.

To install the 1010 PCI card into your computer

1.Make sure that the power switch on your computer is off.

IMPORTANT: Unplug the power cord from the wall outlet!

2.Touch a metal plate on your computer to ground yourself and to discharge any static electricity.

3.Follow the computer manufacturer’s recommended procedure for opening the case.

4.Remove the metal brackets from two adjacent PCI slots. If you have the E-MU 1820 system (non-M) you only need to remove the bracket from a single PCI slot. Put the screw(s) aside for use later. See figure 1 below.

E Note: Some

computer cases don’t use

screws to secure PCI

cards. In this case, follow

Figure 1

PCI

Slo ts

on(may	ISA
no
your	t	Slots
	c be
	omputer		t
		presen
		)

Figure 2

the instructions that

came with your

computer.

5.Align the E-MU 1010 PCI card with the slot and press gently but firmly down into the slot as shown in figure 2.

6.Do not force the E-MU 1010 card into the slot. Make sure that the gold finger connector of the card is aligned with the PCI bus connector on the motherboard before you insert the card into the PCI slot. If it doesn’t fit properly, gently remove it and try again.

7.Secure the card into the slot using one of the screws you placed aside earlier.

E-MU Digital Audio System 11