
7auxes | HPWTM owner’s manual | |
|
|
|
aux connectors-rear panel
The HPW Aux output connections are located on the Master rear output panel. All of the auxiliary outputs are fully balanced with auxes
52aux output 1/4"TRS and male XLR jacks
The aux output signal is available at this output jack.The output is fully balanced.
Tip positive, Ring negative, Sleeve is Chassis Ground Outputs
Max Output Level= +26dBu (into 2kΩ or higher)
53insert jack 1/4"TRS jack
This switching 1/4” TRS jack allows an external signal processor to be inserted into the signal path of the aux bus.The tip carries the SEND signal from the aux, and the ring carries the RETURN signal back to the aux.The
Send (output) impedance is 50Ω
Return (input) impedance is 5KΩ Nominal Operating Level=
NOTE: To avoid any degradation of the HPW’s aux signal, any processing gear patched into the insert jack should have a low impedance output (<100Ω) and must be capable of cleanly driving a 2KΩ load to +21dBu.
NOTE: The | Fader- | + |
| ||
Reverse | switch |
|
does not change the |
|
function of any of the rear- panel jacks. The Aux Output and Insert jacks are always located here. Similarly, the Group Output and Insert jacks always retain their same function.
52 53
p.34